Do you want a guide that tells you, step by step, how to mount a tap of the art? In "Mount Faucet" we give you all the advice to avoid mistakes!
Fit a tap is not an insurmountable obstacle even for those without experience, thanks to our guide Mount Faucet, in fact, we put at your disposal the experience to help you carry out this task independently.
We will look at models of tap today's most popular offering fundamental information to mount the faucet properly and with maximum efficiency.
Movable tube mixers
We start with our guide Faucet Mount considering those are the classic kitchen mixers generally characterized by a long beak oscillating from side to side. They have a single point of attachment to the sink where the pipes pass through both of which provide hot and cold water. How to mount? Follow the guide Mount Faucet
1. Look closely at the two connections for hot and cold: in the vicinity of the sink you will not have to do is to connect hoses (red and blue eyes to be met).
2. Tighten the faucet to the sink through the bolt must be screwed into threaded around the edge of the mixer itself below the sink.
3. The spout from which water flows can occur apart. It is simply screwed on the basis of careful insertion of the correct gasket.
Wall mixers
Very popular for baths, but still present in older kitchens, are those who have installed taps on the wall: in this case the water pipes emerge directly from the plant to be incorporated into the wall. Eco driving tips do you mount faucet.
1. Very simple: these taps are usually sold in one piece with the exception of the bill that could be taken apart and screwed into the threaded hole.
2. Protrude from the wall the water pipes with threaded ends: it is screwed to the tap by means of the bolts are in kit form and making sure to apply the seals.
Mixers
They are especially typical of the bathroom sinks for which our guide could not help but tap Install mention the installation. A little 'as it is for kitchen taps, these include single-lever from the bottom of the output tubes to be connected to hoses of hot and cold water.
1. Pass the pipe in the hole in the blender in the sink and connect the flexible system.
2. Using the bolts provided in kit to fix the attachment of the mixer sink.